I attached a file that has graphs that show what is happening. Worksheets from THR5 up to THRS9 and LOWMGEN are the ones relevant and the difference between them is the period of ELP and OGM. But changing them didn't make much of a difference in the end so we can just look at THR5. We normally have 4 routers but for the test we are simulating, we used network 1 whose throughput is 30000 kbps and network 3 whose throughput is 8000 kbps and we give those values to batman with throughput_override. Graph shows the amount of OGM and ELP packets sent by node-1 from network 1 and 3 that were able to reach node-2, also PDR (packet delivery ratio) which starts dropping heavily thanks to packet loss and then picks back up when switching to network 3. Node-2 connection NW graph shows which network is chosen by batman, it's network 1 at first, then 3 etc. In the test scenario, two nodes move away from each other so packet loss increases over time but it increases more in network 1, and since the throughput values are overriden, batman still chooses that network based on that value. Only when OGM messages stop reaching in network 1, batman switches to network 3 and we see the PDR increasing to 1 immediately when that happens. Basically we want batman to be able to switch earlier than that and that's why I asked about the throughput meter implementation because the batman overriden throughput value doesn't consider packet losses. Another idea we had was to manually change the throughput value via a script if packet loss increases too much or something like that, we haven't thought in detail yet. So I'm asking if you could have any suggestion that considers packet loss as well. Otherwise, I'd also appreciate the assistance you could provide for the patches for tp fallback implementation. Does it work at all at its current state even with problems or is it not there yet? The set up is that we have custom routers connected to ethernet ports of Ubuntu computers and in the simulation, they are set up with virtually. I don't think the details matter because without tp override ethtool is used and it just gives the maximum physical layer speed which Sven Eckelmann also mentions in the last reply in https://lists.open-mesh.org/mailman3/hyperkitty/list/b.a.t.m.a.n@lists.open-mesh.org/thread/AJYTJOONPCJ2GSPSTOFTTO5TZQKYJGOZ/