messages from 2015-03-27 18:52:42 to 2015-06-05 06:15:29 UTC [more...]
[PATCH v2 0/2] Add MediaTek display PWM driver
2015-06-05 6:15 UTC (5+ messages)
` [PATCH v2 1/2] dt-bindings: pwm: add MediaTek display PWM bindings
` [PATCH v2 2/2] pwm: add MediaTek display PWM driver support
[PATCH 00/21] On-demand device registration
2015-06-04 21:03 UTC (12+ messages)
` [PATCH 14/21] pwm: Probe PWM chip devices on demand
[PATCH v2 0/5] Add support for PWMSS on DRA7
2015-06-03 11:51 UTC (6+ messages)
` [PATCH v2 1/5] ARM: OMAP2+: DRA7: clockdomain: change l4per2_7xx_clkdm to SW_WKUP
` [PATCH v2 2/5] ARM: OMAP2+: DRA7: Add hwmod entries for PWMSS
` [PATCH v2 3/5] ARM: dts: DRA7: Add TBCLK "
` [PATCH v2 4/5] clk: ti: DRA7: Add tbclk data for ehrpwm
` [PATCH v2 5/5] ARM: dts: DRA7: Add dt nodes for PWMSS
[PATCH 0/5] Add support for PWMSS on DRA7
2015-06-02 11:24 UTC (10+ messages)
` [PATCH 1/5] ARM: OMAP2+: DRA7: clockdomain: change l4per2_7xx_clkdm to SW_WKUP
` [PATCH 2/5] ARM: OMAP2+: DRA7: Add hwmod entries for PWMSS
` [PATCH 3/5] ARM: dts: DRA7: Add TBCLK "
` [PATCH 4/5] clk: ti: DRA7: Add tbclk data for ehrpwm
` [PATCH 5/5] ARM: dts: DRA7: Add dt nodes for PWMSS
[PATCH v8 0/5] Fix bugs in kona pwm driver and pwm core
2015-05-30 16:42 UTC (8+ messages)
` [PATCH v8 1/5] drivers: pwm: core: Add pwmchip_add_inversed
` [PATCH v8 2/5] drivers: pwm: bcm-kona: Dont set polarity in probe
` [PATCH v8 3/5] pwm: kona: Fix incorrect config, disable, and polarity procedures
` [PATCH v8 4/5] pwm: kona: Add debug info to config function
` [PATCH v8 5/5] pwm: core: Set enable state properly on failed call to enable
[PATCH] pwm: ftm: fix clock enable/disable when using PM
2015-05-29 20:48 UTC
[PATCH v4 0/2] pwm: Add support for R-Car PWM Timer
2015-05-28 10:11 UTC (4+ messages)
` [PATCH v4 1/2] pwm: Add device tree binding document "
` [PATCH v4 2/2] pwm: Add support "
[PATCH] backlight: pwm: handle EPROBE_DEFER while requesting the PWM
2015-05-26 21:20 UTC (5+ messages)
` [NEXT REQUEST][PATCH] "
[PATCH 1/2] PWM: atmel: fix incorrect CDTY value after enabling
2015-05-26 11:51 UTC (7+ messages)
` [PATCH 2/2] PWM: atmel: fix incorrect CDTY value after disabling
` [PATCHv2 "
[PATCH 0/2] Add Mediatek display PWM driver
2015-05-26 8:29 UTC (17+ messages)
` [PATCH 1/2] dt-bindings: pwm: add Mediatek display PWM bindings
` [PATCH 2/2] pwm: add Mediatek display PWM driver support
[PATCH v7 0/5] Fix bugs in kona pwm driver and pwm core
2015-05-25 17:33 UTC (9+ messages)
` [PATCH v7 1/5] drivers: pwm: core: Add pwmchip_add_inversed
` [PATCH v7 2/5] drivers: pwm: bcm-kona: Dont set polarity in probe
` [PATCH v7 3/5] pwm: kona: Fix incorrect config, disable, and polarity procedures
` [PATCH v7 4/5] pwm: kona: Add debug info to config function
` [PATCH v7 5/5] pwm: core: Set enable state properly on failed call to enable
[PATCH v3 0/2] pwm: Add support for R-Car PWM Timer
2015-05-21 9:27 UTC (7+ messages)
` [PATCH v3 1/2] pwm: Add device tree binding document "
` [PATCH v3 2/2] pwm: Add support "
[PATCH] pwm: samsung: Use MODULE_DEVICE_TABLE() to include OF modalias
2015-05-21 8:20 UTC (5+ messages)
[PATCH 0/8] Crystalcove (CRC) PMIC based panel and pwm control
2015-05-20 15:09 UTC (41+ messages)
` [PATCH 1/8] drivers/gpio/gpiolib: Add support for removing registered consumer lookup table
` [PATCH 1/8] gpiolib: "
` [Intel-gfx] "
` [Intel-gfx] [PATCH 1/8] drivers/gpio/gpiolib: "
` [PATCH 2/8] drivers/pwm/core: Add support to remove registered consumer lookup tables
` [PATCH 2/8] pwm: core: "
` [PATCH 3/8] drivers/mfd: Add lookup table for Panel Control as GPIO signal
` [PATCH 3/8] mfd: intel_soc_pmic_core: "
` [PATCH 4/8] drivers/mfd: Add PWM cell device for Crystalcove PMIC
` [PATCH 4/8] mfd: intel_soc_pmic_crc: "
` [PATCH 5/8] drivers/mfd: ADD PWM lookup table for CRC PMIC based PWM
` [PATCH 5/8] mfd: intel_soc_pmic_core: "
` [PATCH 6/8] drivers/pwm: Add Crystalcove (CRC) PWM driver
` [PATCH 6/8] pwm: crc: "
` [Intel-gfx] "
` [PATCH 7/8] drm/i915: Use the CRC gpio for panel enable/disable
` [PATCH 8/8] drm/i915: Backlight control using CRC PMIC based PWM driver
[PATCH v2 0/2] pwm: Add support for R-Car PWM Timer
2015-05-20 2:36 UTC (7+ messages)
` [PATCH v2 1/2] pwm: Add device tree binding document "
` [PATCH v2 2/2] pwm: Add support "
[PATCH] pwm: img: Change min and max timebase steps value
2015-05-19 14:15 UTC (4+ messages)
` [PATCH v2] pwm: img: Impose upper and lower "
[GIT PULL] pwm: Fixes for v4.1-rc5
2015-05-19 14:13 UTC
[PATCH] backlight: pwm_bl: Simplify usage of devm_gpiod_get_optional
2015-05-19 9:18 UTC (4+ messages)
[PATCH 0/2] pwm: Add support for R-Car PWM Timer
2015-05-15 1:15 UTC (7+ messages)
` [PATCH 1/2] pwm: Add device tree binding document "
` [PATCH 2/2] pwm: Add support "
[PATCH v6 0/4] Fix bugs in kona pwm driver and pwm core
2015-05-11 20:14 UTC (9+ messages)
` [PATCH v6 1/4] drivers: pwm: core: Add pwmchip_add_inversed
` [PATCH v6 2/4] drivers: pwm: bcm-kona: Dont set polarity in probe
` [PATCH v6 3/4] pwm: kona: Fix incorrect config, disable, and polarity procedures
` [PATCH v6 4/4] pwm: core: Set enable state properly on failed call to enable
[GIT PULL] pwm: Changes for v4.1-rc1
2015-04-23 12:58 UTC
[PATCH] pwm: Add clk enable/disable for pwm_samsung_enable/pwm_samsung_disable
2015-04-15 10:17 UTC (3+ messages)
[PATCH v5] clk: Add PWM clock driver
2015-04-10 21:45 UTC (3+ messages)
Exynos5422 odroidxu3 pwm-fan control using thermal sensors
2015-04-10 17:58 UTC (34+ messages)
` [PATCH 1/6] ARM: dts :exynos5422-odroidxu3 Add pwm-fan node to the Odroid-XU3 board
` [PATCH 2/6] ARM: dts exynos5420 update the cooling cells for core cpu0
` [PATCH 3/6] ARM:dts exynos5422 Update the thermal sensor for tmu_cpu0
` [PATCH 4/6] ARM: dts: OdroidXU3: Enable TMU at Exynos5422 base
` [PATCH 5/6] pwm: samsung: Fix output race on disabling
` [PATCH 6/6] hwmon: pwm-fan: Update the duty cycle inorder to control the pwm-fan
[PATCH 0/2] leds/pwm: don't call pwm_disable when setting brightness
2015-03-27 18:49 UTC (8+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).