From: Manikanta Pubbisetty <quic_mpubbise@quicinc.com>
To: <ath11k@lists.infradead.org>
Cc: <linux-wireless@vger.kernel.org>, <devicetree@vger.kernel.org>,
<robh@kernel.org>,
Manikanta Pubbisetty <quic_mpubbise@quicinc.com>
Subject: [PATCH v2 15/19] ath11k: WMI changes to support WCN6750
Date: Sun, 16 Jan 2022 18:17:11 +0530 [thread overview]
Message-ID: <1642337235-8618-16-git-send-email-quic_mpubbise@quicinc.com> (raw)
In-Reply-To: <1642337235-8618-1-git-send-email-quic_mpubbise@quicinc.com>
WCN6750 is a single PDEV non-DBS chip which supports 2G, 5G and 6G bands.
It is a single LMAC device which can be either hooked to 2G/5G/6G bands.
Add WMI changes to support WCN6750.
Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00573-QCAMSLSWPLZ-1
Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1
Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.5.0.1-01100-QCAHKSWPL_SILICONZ-1
Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.4.0.1-00192-QCAHKSWPL_SILICONZ-1
Signed-off-by: Manikanta Pubbisetty <quic_mpubbise@quicinc.com>
---
drivers/net/wireless/ath/ath11k/wmi.c | 10 +++++++---
1 file changed, 7 insertions(+), 3 deletions(-)
diff --git a/drivers/net/wireless/ath/ath11k/wmi.c b/drivers/net/wireless/ath/ath11k/wmi.c
index 0cc8957..ca7bb11 100644
--- a/drivers/net/wireless/ath/ath11k/wmi.c
+++ b/drivers/net/wireless/ath/ath11k/wmi.c
@@ -389,6 +389,10 @@ ath11k_pull_mac_phy_cap_svc_ready_ext(struct ath11k_pdev_wmi *wmi_handle,
ab->target_pdev_ids[ab->target_pdev_count].pdev_id = mac_phy_caps->pdev_id;
ab->target_pdev_count++;
+ if (!(mac_phy_caps->supported_bands & WMI_HOST_WLAN_2G_CAP) &&
+ !(mac_phy_caps->supported_bands & WMI_HOST_WLAN_5G_CAP))
+ return -EINVAL;
+
/* Take non-zero tx/rx chainmask. If tx/rx chainmask differs from
* band to band for a single radio, need to see how this should be
* handled.
@@ -396,7 +400,9 @@ ath11k_pull_mac_phy_cap_svc_ready_ext(struct ath11k_pdev_wmi *wmi_handle,
if (mac_phy_caps->supported_bands & WMI_HOST_WLAN_2G_CAP) {
pdev_cap->tx_chain_mask = mac_phy_caps->tx_chain_mask_2g;
pdev_cap->rx_chain_mask = mac_phy_caps->rx_chain_mask_2g;
- } else if (mac_phy_caps->supported_bands & WMI_HOST_WLAN_5G_CAP) {
+ }
+
+ if (mac_phy_caps->supported_bands & WMI_HOST_WLAN_5G_CAP) {
pdev_cap->vht_cap = mac_phy_caps->vht_cap_info_5g;
pdev_cap->vht_mcs = mac_phy_caps->vht_supp_mcs_5g;
pdev_cap->he_mcs = mac_phy_caps->he_supp_mcs_5g;
@@ -406,8 +412,6 @@ ath11k_pull_mac_phy_cap_svc_ready_ext(struct ath11k_pdev_wmi *wmi_handle,
WMI_NSS_RATIO_ENABLE_DISABLE_GET(mac_phy_caps->nss_ratio);
pdev_cap->nss_ratio_info =
WMI_NSS_RATIO_INFO_GET(mac_phy_caps->nss_ratio);
- } else {
- return -EINVAL;
}
/* tx/rx chainmask reported from fw depends on the actual hw chains used,
--
2.7.4
next prev parent reply other threads:[~2022-01-16 12:48 UTC|newest]
Thread overview: 49+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-01-16 12:46 [PATCH v2 00/19] add support for WCN6750 Manikanta Pubbisetty
2022-01-16 12:46 ` [PATCH v2 01/19] ath11k: PCI changes to support WCN6750 Manikanta Pubbisetty
2022-01-16 12:46 ` [PATCH v2 02/19] ath11k: Refactor PCI code to support hybrid bus devices Manikanta Pubbisetty
2022-01-28 10:16 ` Kalle Valo
2022-02-25 5:50 ` Manikanta Pubbisetty
2022-03-08 6:00 ` Manikanta Pubbisetty
2022-01-28 12:13 ` Kalle Valo
2022-02-21 8:04 ` Manikanta Pubbisetty
2022-02-21 9:19 ` Kalle Valo
2022-02-21 10:19 ` Manikanta Pubbisetty
2022-01-16 12:46 ` [PATCH v2 03/19] ath11k: Choose MSI config based on HW revision Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 04/19] ath11k: Refactor MSI logic Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 05/19] ath11k: Remove core PCI references from PCI common code Manikanta Pubbisetty
2022-01-28 10:20 ` Kalle Valo
2022-01-28 10:37 ` Kalle Valo
2022-02-21 7:07 ` Manikanta Pubbisetty
2022-02-21 9:21 ` Kalle Valo
2022-02-21 6:55 ` Manikanta Pubbisetty
2022-02-21 9:17 ` Kalle Valo
2022-02-21 10:08 ` Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 06/19] ath11k: Add HW params for WCN6750 Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 07/19] ath11k: Add bus " Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 08/19] ath11k: Add register access logic " Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 09/19] ath11k: Fetch device information via QMI " Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 10/19] ath11k: Add QMI changes " Manikanta Pubbisetty
2022-01-28 10:50 ` Kalle Valo
2022-02-21 8:02 ` Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 11/19] ath11k: HAL changes to support WCN6750 Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 12/19] ath11k: Datapath " Manikanta Pubbisetty
2022-04-27 5:32 ` Kalle Valo
2022-04-27 5:37 ` Manikanta Pubbisetty
2022-04-27 5:48 ` Kalle Valo
2022-04-27 5:56 ` Manikanta Pubbisetty
2022-04-29 8:56 ` Kalle Valo
2022-01-16 12:47 ` [PATCH v2 13/19] ath11k: Fix RX de-fragmentation issue on WCN6750 Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 14/19] ath11k: Do not put HW in DBS mode for WCN6750 Manikanta Pubbisetty
2022-01-16 12:47 ` Manikanta Pubbisetty [this message]
2022-01-16 12:47 ` [PATCH v2 16/19] ath11k: Update WBM idle ring HP after FW mode on Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 17/19] ath11k: Add support for WCN6750 device Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 18/19] ath11k: Add support for targets without trustzone Manikanta Pubbisetty
2022-01-28 10:42 ` Kalle Valo
2022-02-21 8:00 ` Manikanta Pubbisetty
2022-01-16 12:47 ` [PATCH v2 19/19] dt: bindings: net: add bindings of WCN6750 for ath11k Manikanta Pubbisetty
2022-01-28 10:39 ` Kalle Valo
2022-02-21 7:08 ` Manikanta Pubbisetty
2022-02-07 22:13 ` Rob Herring
2022-02-25 11:34 ` Manikanta Pubbisetty
2022-01-28 10:07 ` [PATCH v2 00/19] add support for WCN6750 Kalle Valo
2022-02-21 6:29 ` Manikanta Pubbisetty
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1642337235-8618-16-git-send-email-quic_mpubbise@quicinc.com \
--to=quic_mpubbise@quicinc.com \
--cc=ath11k@lists.infradead.org \
--cc=devicetree@vger.kernel.org \
--cc=linux-wireless@vger.kernel.org \
--cc=robh@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).