From: Miquel Raynal <miquel.raynal@bootlin.com>
To: Alexander Aring <alex.aring@gmail.com>,
Stefan Schmidt <stefan@datenfreihafen.org>,
linux-wpan@vger.kernel.org,
"David S. Miller" <davem@davemloft.net>,
Jakub Kicinski <kuba@kernel.org>,
netdev@vger.kernel.org
Cc: David Girault <david.girault@qorvo.com>,
Romuald Despres <romuald.despres@qorvo.com>,
Frederic Blain <frederic.blain@qorvo.com>,
Nicolas Schodet <nico@ni.fr.eu.org>,
Thomas Petazzoni <thomas.petazzoni@bootlin.com>,
linux-wireless@vger.kernel.org,
Miquel Raynal <miquel.raynal@bootlin.com>
Subject: [wpan-tools v2 5/7] iwpan: Synchronize nl802154 header with the Linux kernel
Date: Wed, 12 Jan 2022 18:35:27 +0100 [thread overview]
Message-ID: <20220112173529.765170-6-miquel.raynal@bootlin.com> (raw)
In-Reply-To: <20220112173529.765170-1-miquel.raynal@bootlin.com>
The content of this file as evolved, reflect the changes accepted in the
mainline Linux kernel here.
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
src/nl802154.h | 99 ++++++++++++++++++++++++++++++++++++++++++++++++++
1 file changed, 99 insertions(+)
diff --git a/src/nl802154.h b/src/nl802154.h
index ddcee12..9bb136a 100644
--- a/src/nl802154.h
+++ b/src/nl802154.h
@@ -56,6 +56,16 @@ enum nl802154_commands {
NL802154_CMD_SET_WPAN_PHY_NETNS,
+ NL802154_CMD_TRIGGER_SCAN,
+ NL802154_CMD_ABORT_SCAN,
+ NL802154_CMD_SCAN_DONE,
+ NL802154_CMD_DUMP_PANS,
+ NL802154_CMD_FLUSH_PANS,
+ NL802154_CMD_SET_MAX_PAN_ENTRIES,
+ NL802154_CMD_SET_PANS_EXPIRATION,
+ NL802154_CMD_SEND_BEACONS,
+ NL802154_CMD_STOP_BEACONS,
+
/* add new commands above here */
#ifdef CONFIG_IEEE802154_NL802154_EXPERIMENTAL
@@ -131,6 +141,15 @@ enum nl802154_attrs {
NL802154_ATTR_PID,
NL802154_ATTR_NETNS_FD,
+ NL802154_ATTR_SCAN_TYPE,
+ NL802154_ATTR_SCAN_FLAGS,
+ NL802154_ATTR_SCAN_CHANNELS,
+ NL802154_ATTR_SCAN_DURATION,
+ NL802154_ATTR_PAN,
+ NL802154_ATTR_MAX_PAN_ENTRIES,
+ NL802154_ATTR_PANS_EXPIRATION,
+ NL802154_ATTR_BEACON_INTERVAL,
+
/* add attributes here, update the policy in nl802154.c */
#ifdef CONFIG_IEEE802154_NL802154_EXPERIMENTAL
@@ -217,6 +236,86 @@ enum nl802154_wpan_phy_capability_attr {
NL802154_CAP_ATTR_MAX = __NL802154_CAP_ATTR_AFTER_LAST - 1
};
+/**
+ * enum nl802154_scan_types - Scan types
+ *
+ * @__NL802154_SCAN_INVALID: scan type number 0 is reserved
+ * @NL802154_SCAN_ED: An ED scan allows a device to obtain a measure of the peak
+ * energy in each requested channel
+ * @NL802154_SCAN_ACTIVE: Locate any coordinator transmitting Beacon frames using
+ * a Beacon Request command
+ * @NL802154_SCAN_PASSIVE: Locate any coordinator transmitting Beacon frames
+ * @NL802154_SCAN_ORPHAN: Relocate coordinator following a loss of synchronisation
+ * @NL802154_SCAN_ENHANCED_ACTIVE: Same as Active using Enhanced Beacon Request
+ * command instead of Beacon Request command
+ * @NL802154_SCAN_RIT_PASSIVE: Passive scan for RIT Data Request command frames
+ * instead of Beacon frames
+ * @NL802154_SCAN_ATTR_MAX: Maximum SCAN attribute number
+ */
+enum nl802154_scan_types {
+ __NL802154_SCAN_INVALID,
+ NL802154_SCAN_ED,
+ NL802154_SCAN_ACTIVE,
+ NL802154_SCAN_PASSIVE,
+ NL802154_SCAN_ORPHAN,
+ NL802154_SCAN_ENHANCED_ACTIVE,
+ NL802154_SCAN_RIT_PASSIVE,
+
+ /* keep last */
+ NL802154_SCAN_ATTR_MAX,
+};
+
+/**
+ * enum nl802154_scan_flags - Scan request control flags
+ *
+ * @NL802154_SCAN_FLAG_RANDOM_ADDR: use a random MAC address for this scan (ie.
+ * a different one for every scan iteration). When the flag is set, full
+ * randomisation is assumed.
+ */
+enum nl802154_scan_flags {
+ NL802154_SCAN_FLAG_RANDOM_ADDR = 1 << 0,
+};
+
+/**
+ * enum nl802154_pan - Netlink attributes for a PAN
+ *
+ * @__NL802154_PAN_INVALID: invalid
+ * @NL802154_PAN_PANID: PANID of the PAN (2 bytes)
+ * @NL802154_PAN_COORD_ADDR: Coordinator address, (8 bytes or 2 bytes)
+ * @NL802154_PAN_CHANNEL: channel number, related to @NL802154_PAN_PAGE (u8)
+ * @NL802154_PAN_PAGE: channel page, related to @NL802154_PAN_CHANNEL (u8)
+ * @NL802154_PAN_PREAMBLE_CODE: Preamble code while the beacon was received,
+ * this is PHY dependent and optional (4 bytes)
+ * @NL802154_PAN_SUPERFRAME_SPEC: superframe specification of the PAN (u16)
+ * @NL802154_PAN_LINK_QUALITY: signal quality of beacon in unspecified units,
+ * scaled to 0..255 (u8)
+ * @NL802154_PAN_GTS_PERMIT: set to true if GTS is permitted on this PAN
+ * @NL802154_PAN_PAYLOAD_DATA: binary data containing the raw data from the
+ * frame payload, (only if beacon or probe response had data)
+ * @NL802154_PAN_STATUS: status, if this PAN is "used"
+ * @NL802154_PAN_SEEN_MS_AGO: age of this PAN entry in ms
+ * @NL802154_PAN_PAD: attribute used for padding for 64-bit alignment
+ * @NL802154_PAN_MAX: highest PAN attribute
+ */
+enum nl802154_pan {
+ __NL802154_PAN_INVALID,
+ NL802154_PAN_PANID,
+ NL802154_PAN_COORD_ADDR,
+ NL802154_PAN_CHANNEL,
+ NL802154_PAN_PAGE,
+ NL802154_PAN_PREAMBLE_CODE,
+ NL802154_PAN_SUPERFRAME_SPEC,
+ NL802154_PAN_LINK_QUALITY,
+ NL802154_PAN_GTS_PERMIT,
+ NL802154_PAN_PAYLOAD_DATA,
+ NL802154_PAN_STATUS,
+ NL802154_PAN_SEEN_MS_AGO,
+ NL802154_PAN_PAD,
+
+ /* keep last */
+ NL802154_PAN_MAX,
+};
+
/**
* enum nl802154_cca_modes - cca modes
*
--
2.27.0
next prev parent reply other threads:[~2022-01-12 17:35 UTC|newest]
Thread overview: 8+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-01-12 17:35 [wpan-tools v2 0/7] IEEE 802.15.4 scan support Miquel Raynal
2022-01-12 17:35 ` [wpan-tools v2 1/7] iwpan: Fix the channels printing Miquel Raynal
2022-01-12 17:35 ` [wpan-tools v2 2/7] iwpan: Export iwpan_debug Miquel Raynal
2022-01-12 17:35 ` [wpan-tools v2 3/7] iwpan: Fix a comment Miquel Raynal
2022-01-12 17:35 ` [wpan-tools v2 4/7] iwpan: Remove duplicated SECTION Miquel Raynal
2022-01-12 17:35 ` Miquel Raynal [this message]
2022-01-12 17:35 ` [wpan-tools v2 6/7] iwpan: Add full scan support Miquel Raynal
2022-01-12 17:35 ` [wpan-tools v2 7/7] iwpan: Add events support Miquel Raynal
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20220112173529.765170-6-miquel.raynal@bootlin.com \
--to=miquel.raynal@bootlin.com \
--cc=alex.aring@gmail.com \
--cc=davem@davemloft.net \
--cc=david.girault@qorvo.com \
--cc=frederic.blain@qorvo.com \
--cc=kuba@kernel.org \
--cc=linux-wireless@vger.kernel.org \
--cc=linux-wpan@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=nico@ni.fr.eu.org \
--cc=romuald.despres@qorvo.com \
--cc=stefan@datenfreihafen.org \
--cc=thomas.petazzoni@bootlin.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for read-only IMAP folder(s) and NNTP newsgroup(s).